Divider tray - rows and dividers

Settings for Finger Joints

style style of the fingers
surroundingspacesmaximum space at the start and end in multiple of normal spaces
edge_widthspace below holes of FingerHoleEdge
fingerwidth of the fingers
playextra space to allow finger move in and out
spacespace between fingers
widthwidth of finger holes

DividerTray Settings

sxsections left to right in mm. See --sy for format
sysections back to front in mm. Possible formats: overallwidth/numberof sections e.g. "250/5"; sectionwidth*numberofsections e.g. "50*5"; section widths separated by ":" e.g. "30:25.5:70
hinner height in mm (unless outside selected)
outside treat sizes as outside measurements that include the walls
slot_depthdepth of the slot in mm
slot_angleangle at which slots are generated, in degrees. 0° is vertical.
slot_radiusradius of the slot entrance in mm
slot_extra_slackextra slack (in addition to thickness and kerf) for slot width to help insert dividers
divider_bottom_marginmargin between box's bottom and divider's
divider_upper_notch_radiusdivider's notch's upper radius
divider_lower_notch_radiusdivider's notch's lower radius
divider_notch_depthdivider's notch's depth
left_wall generate wall on the left side
right_wall generate wall on the right side
bottom generate wall on the bottom

Default Settings

thicknessthickness of the material
format format of resulting file
tabswidth of tabs holding the parts in place in mm (not supported everywhere)
debug print surrounding boxes for some structures
labels label the parts (where available)
referenceprint reference rectangle with given length (zero to disable)
burnburn correction in mm (bigger values for tighter fit). Use BurnTest in "Parts and Samples" to find the right value.