Boxes.py

self-Logo

DrillStand

Box for drills with each compartment of a different height

Settings for Stackable Edges

Settings for Finger Joints

DrillStand Settings

Default Settings


Note: sh gives the hight of the rows front to back. It though should have the same number of entries as sy. These heights are the one on the left side and increase throughout the row. To have each compartement a bit higher than the previous one the steps in sh should be a bit bigger than extra_height.

Assembly:

Parts

Start with putting the slots of the inner walls together. Be especially careful with adding the bottom. It is always assymetrical and flush with the right/lower side while being a little short on the left/higher side to not protrude into the side wall.

Assembly inner walls Assembly bottom
Then add the front and the back wall. Add the very left and right walls last.
Assembly front and back Assembly side walls